Halcyon
Gas Fireplace European
Home
.com
24
INSTALLATION
6. INSTALL THE INTERIOR PANELS
a) While wearing gloves, remove any protective film from each of the ten interior panels. Handle the panels with care so as to
leave as few marks as possible. This will make cleaning them easier.
b) Set the left and right side panels (1, 2) into place in the order shown in
Figure 20.
Fasten panels 1 and 2 with their top clips.
c) Set the four rear panels (3, 4, 5, 6) into place as shown in
Figure 20
. Fasten panels 3 and 4 and panels 5 and 6 with the top clips.
Ensure that there are no gaps between the panels and that they are centered.
d) Set the four bottom panels (7, 8, 9, 10) into place in the order shown in
Figure 20
.
e) Clean all of the panels completely
before
the First Fire. If the panels are not completely clean the heat can cause permanent
stains. See the MAINTENANCE section.
1
2
3
5
6
7
8
9
10
4
Figure 20 - Halcyon Panel Numbers
7. INSTALL THE MEDIA
The contents of the bag of Burner Media should be spread to an even depth over the entire burner top.
a) Cut one corner of the bag to form a pouring spout through which the flow of Media can be controlled.
b) Begin at the left end pour the Media onto the center of the burner tray while moving to your right. Care should be taken to
avoid spilling the Media into the bottom of the cabinet. Note that if some spillage does occur there will be no harm but less
Media.
c) After the bag has been emptied on the burner carefully smooth the Media to a uniform depth on the tray.
Be certain that glass
does not come within 1/4” of the pilot burner hood. Both parts of the pilot flame must be present as in Figure 21.
d) If you have ordered other Media, such as Stones, lay it on and around the burner taking care to avoid covering more than 10
percent of the opening between the burner top and the hearth panels.
Figure 20
shows Stainless Steel panels; other panel types are also available.
