HAKO Citymaster 2200, Руководство по эксплуатации, Страница: 113 / 238

03-1481-00-00.fm
113
Operation
Moving off
Observe the Safety instructions – Starting the vehicle and moving off, see
page 110.
After starting the engine:
1. Preselect the driving mode with the tip switch
Fig. 81-95
, see page 103.
The respective symbol appears in the multifunction display:
•
Transport mode
Fig. 81-130
•
Work mode
Fig. 81-129
2. Preselect the steering mode with the tip switch
Fig. 81-93
, see page
100. The respective symbol appears in the multifunction display.
•
Front wheel steering
Fig. 81-C
•
Four-wheel steering (only in work mode)
Fig. 81-D
3. Preselect the driving direction with the switch
Fig. 81-56
.
4. Release the parking brake
Fig. 81-55
.
•
The warning light
Fig. 81-139
in the indicating device goes out.
5. Slowly apply the accelerator pedal
Fig. 81-49
.
6. Test the brakes when travelling at low speed. Check in the rearview
mirror to ensure that a braking manoeuvre will not cause any kind of
obstruction.
7. Always warm the engine up before running it under full load.
56
95
Fig. 81:
139 A B
55
F
R
N
49
93
C
D
130
129
Attention
Make sure that the parking brake is released – driving with the
parking brake applied overheats the parking brake and
causes it to break.
Note
If the driver is not on the driver's seat when the engine is
running, the warning symbol
Fig. 81-A
appears in the multi-
function display.
Attention
At hydraulic oil temperatures below 25 °C, the diesel speed is
limited by the drive control to prevent damage to the hydraulic
pumps.
If the pressure filter of the drive pump is contaminated, the
warning symbol
Fig. 81-B
appears in the multifunction dis-
play. The drive pump no longer supplies the full delivery rate
and the vehicle does not achieve maximum speed. Inform an
authorised workshop.