HAKO Citymaster 2200, Руководство по эксплуатации

Страница: 111 / 238

03-1481-00-00.fm
111
Operation
Starting the vehicle
Observe the Safety instructions – Starting the vehicle and moving off, see
page 110.
1. Insert ignition key into the ignition switch
Fig. 79-107
.
2. Turn the ignition key to position "I".
•
The warning lights
Fig. 79-131 and 132
light up.
•
The warning light
Fig. 79-139
lights up when parking brake
Fig. 79-
is
applied.
55
•
The telltale
Fig. 79-141
lights up when the attachment is raised or not
fully lowered.
3. At low temperatures:
•
The engine is preheated until the telltale
Fig. 79-133
goes out. The
engine must be started immediately after the telltale
Fig. 79-133
has
gone out.
4. Do not actuate the accelerator pedal
Fig. 79-49
during the starting
procedure.
5. Turn the ignition key to position "II" and hold it in this position until the
engine starts.
6. Release the ignition key
.
0
107
139
Fig. 79:
141
133
132 131
55
49
P
I
II
Note
The starter cannot be actuated when the engine is already
running (start repeat lock). Do not run the starter for more
than 10 seconds. Wait for about 1 minute to let the battery
recover before trying again.
Note
The engine can only be started when battery master switch
(option) is switched on, the driving switch is in the neutral
position and accelerator pedal is not depressed.
Attention
Never let the vehicle roll when the diesel engine is not run-
ning. In this case,
•
there is no power steering through the diesel engine.
• there is no brake servo through the diesel engine.
•
hydraulic components of the hydrostatic drive may be
damaged.
For information on recovering the vehicle in case of a break-
down, see see page 119.