Hague Quality Water 96MM, Руководство пользователя

Страница: 4 / 40

ROUTINE CARE
Salt
A brine solution is used during regeneration to remove calcium and
magnesium from the softening resin. Maintain salt level at least 1/3 full; do
not let the brine tank run out of salt. Use solar or pellet salt; do not mix the
two. Be sure to purchase a clean grade of salt. Rock salt is not recommended
because it contains impurities that can plug the injector assembly.
To add salt to the Series 96:
Remove the brine tank lid
Add up to 200 lb (90 kg) of salt to the brine cabinet.
During initial installation, or if the brine tank has been emptied of salt and
water, add 5 gallons (18.9 liters) of water or 2" over grid plate.
When using potassium chloride as an alternative to nugget or pellet salt
(sodium chloride), you must select the potassium option during the
programming of the controller.
We do not recommend the use of Potassium Chloride when iron is
present in the raw water supply.
Disinfection
The Series 96 unit may be disinfected with 5.25% sodium hypochlorite, which
is the active ingredient in household bleach. To disinfect your appliance:
Add four fluid ounces of hypochlorite solution to the brine tank. (The
brine tank should have water in it to permit the solution to be carried into
the softener.)
Initiate a manual regeneration by pressing and holding the REGENERATE
pushbutton for 5 seconds.
WARNING: Do NOT mix bleach with commercial resin cleaners since a
dangerous chemical reaction may occur.
NOTES: ______________________________________________________________________________________
•
•
•
•
Series 96 Owner’s Manual
2
NOTE: When you can see water above
the salt in the brine cabinet, you need
to add salt.