Hague Quality Water 96MM, Руководство пользователя

Страница: 30 / 40

PART NO. QTY ITEM DESCRIPTION
93260 1 Housing Should have a Quad-ring for the Piston seal. The Quad-ring (4) is held in place
by the brine valve retainer(5). The brine valve housing has four retaining lugs
that secure the brine valve retainer. Just inside the entrance hole for the Brine
Piston (1) is a concave seat area that must be free of defects such as nicks,
indentations or debris. If any defects are detected by visual inspection, repair
or replace as needed.
93243-JG 1 Housing Cap The Cap is held in place by two 5/8" machine screws that engage the Housing
Assembly flange. An O-Ring seals the Cap and Housing. Place the O-Ring into the
housing opening, lubricate with silicone grease and then, using a twisting action,
pressure insert the Cap. CAUTION: the 3/8" locking ring (9) must be installed
to prevent air from being drawn into the appliance during brine rinse.
93620 1 Brine Piston The Piston should have an O-Ring on the shaft side of the flange and a spring
pressed onto a boss on the other side. The O-Ring should be free of defects
such as cuts or debris on the shaft side. The Piston is Teflon coated brass and
should be free of scratches. The Piston should move freely in the housing;
silicone lubrication is not recommended on the Piston shaft.
93805 1 O-Ring
90843 1 .5 GPM Flow The Flow Button has two distinct and different sides. One is "flat"; the other is
Control "concave". The button should be centered in the housing opening with the four
locator "ribs" with the concave side facing the Housing Cap.
90807 2 Screw
93803 1 O-Ring
200199 1 3/8" Locking Ring
93254 1 Retainer
93878 1 Quad Ring
90820 1 O-Ring
Series 96 Owner’s Manual
28