Hague Quality Water 96MM, Руководство пользователя

Страница: 26 / 40

Series 96 Owner’s Manual
24
PART NO. QTY ITEM DESCRIPTION
90802 6 Bypass Handle
and Sensor
Housing Screw
and Blending
Valve Cap Screw
90522 1 Turbine Assembly The Turbine has a 1/8" diameter Rare Earth magnet pressed into place adjacent
to the axle opening. When assembled to the axle, the Turbine should spin freely.
Do not use any lubricants. If the Turbine should become “jammed,” clean and
flush the Turbine and openings.
90807 12 End Cap
Mounting Screw
93808 2 End Cap O-ring
90803 1 Drive Shaft
O-ring
90827 1 Blending Valve
O-ring
90828 2 Test Port
O-ring
90812 1 Tubing 4.0 in. (approximate)
93858 1 Turbine Sensor Picks up the magnetic field from the Turbine and relays it to the Controller.
The three wire assembly connecting the “black wafer” Hall Effect Sensor to the
controller board must not be severely bent (folded over,) cut, or broken. Care
should be taken when putting the Sensor into the Sensor Housing. The “spring”
flap below the Sensor must be gently bent over (on top of) the Sensor, and then
the Sensor slides all the way into the Sensor Housing. The round hole of the
Sensor mounting tab is then placed down over the mounting screw boss. The
cap is then put in place and the mounting screw is installed. A slot is provided in
the cap for the wire way to exit. The three-wire socket connector must be
properly installed in the controller. Stops on the connector prevent improper
(upside down) assembly. Do not force the connector past the stops.
90232 1 Turbine Sensor Snaps on. Held in place with screw. Remove screw and pull cap off to remove.
Cap
90809 1 Sensor Cap
Screw
93229 1 Flow Director
93838 2 I/O Adapter
O-ring
90615-94 Bypass Contains all items above
Assembly