Hague Quality Water 96MM, Руководство пользователя

Страница: 37 / 40

EQUIPMENT SPECIFICATIONS - MODEL 96MM
Series 96 Owner’s Manual
35
Maximum compensated hardness* 90 gpg / 1,541 mg/l
Maximum ferrous iron reduction* 10 ppm reduced to below 0.3 ppm
Minimum pH 7
“Ultra-fil” self-cleaning sediment filtration 20 microns nominal
Salt use:Use clean, white pellet or solar salt. 1 lb* - 5,600 grain capacity - .45 kg at 362,880 mg
3 lb* - 15,400 grain capacity - 1.36 kg at 997,920 mg
6 lb - 24,500 grain capacity - 2.72 kg at 1,586,304 mg
9 lb* - 30,700 grain capacity - 4.1 kg at 1,989,360 mg
Media type SUPERSAVER fine mesh cation resin
Media quantity 1 cu. ft, 28.3 l
Water pressure 20 to 120 psi, 138 to 828 kPa
Flow rate (as tested by Hague)
@ 15 psi / 103.4 kPa pressure drop 11 gpm / 41.7 lpm at 103.4 kPa pressure drop
Rated Flow 8 gpm @ 10 psi pressure drop
Maximum flow to drain during regeneration 2.4 gpm / 9.12 lpm
Maximum flow to drain during regeneration 3.0 gpm / 11.4 lpm (96MM B1 or P1 only)
Flow rates: Backwash 2.4 gpm / 9.12 lpm
Brine & Rinse Total .65 gpm
Brine Draw .25 gpm / 1.5 lpm
Rinse .4 gpm / 1.5 lpm/ Service 8 gpm at 10 psi pressure
drop 30.2 lpm at 68.9 kPa pressure drop
Minimum water temperature 40°F, 6°C
Maximum water temperature 120°F, 49°C
Min./Max. ambient temperature 40°F-120°F
Plumbing connection 3/4" or 1" copper pipe
Salt storage capacity 200 lb, 90 kg
Electrical rating 115V, 60 cycle
Unit size 38" H x 15" W x 30" D
96.5 cm H x 38.1 cm W x 76.1 cm D
*1lb, 3 lb and 9 lb settings were tested and certified by WQA. The maximum compensated hardness, maximum ferrous iron
reduction, and 6 lb setting were not tested and certified by WQA.
Model 96MM is the only model tested and certified by WQA.
96MM is efficiency rated according to NSF/ANSI 44. The stated
efficiency is valid only at the specified salt dosage:
Rated efficiency Salt Dosage Capacity at that Dosage
5,600 grains/lb 1.0 lbs 5,600 grains
OPERATIONAL, MAINTENANCE, AND REPLACEMENT REQUIREMENTS ARE ESSENTIAL FOR THE
PRODUCT TO PERFORM TO SPECIFICATIONS.
Conforms to NSF/ANSI Standard 44 for Softening Performance Efficiency, Barium Reduction, and Radium 226/228 Reduction. Water softeners using
sodium chloride for regeneration add sodium to the water. Persons who are on sodium restricted diets should consider the added sodium as part of their
overall sodium intake.
™