Hague Quality Water 96MM, Руководство пользователя

Страница: 22 / 40

SERIES 96 INJECTOR
ASSEMBLY
Series 96 Owner’s Manual
20
Part Number 93501
Figure 6
NO. PART NO. QTY ITEM DESCRIPTION
1 93223 1 Injector Throat Creates the vacuum that draws the brine solution from the brine cabinet in
conjunction with the Injector Nozzle (Part No. 93221). The center hole should be
clear of debris, round, and undamaged. The Injector Throat should be pressed
flush into the opening in the valve. If the Injector Throat is removed, it must be
replaced with a new one.
2 93220 1 Bottom (Thick) Seals between the Injector Nozzle and the Main Valve Body. The gasket has a
Injector Seal definite hole pattern that has to match up with the Nozzle and Main Valve Body
opening. The gasket seals at its outer edges and between the inlet screen and
nozzle opening. These areas must be free of defects such as tearsor pits and
be free of debris.
3 93221 1 Injector Nozzle Creates the vacuum that draws the brine solution from the Brine Cabinet in
conjunction with the Injector Throat (Part No. 93223). There are two openings in
the Injector Nozzle plate. The small hole, flush on both sides, is the one that
creates the “injection-stream” that enters the Injector Throat. It is very important
that this hole be clear of debris, round, and undamaged. If this hole becomes
“clogged,” do not use anything to clear this opening that could damage it, such
as metal objects. Use a clean cloth and flush with water. If necessary, a wooden
toothpick may be used. When assembling to the Main Valve Body, the Injector
Nozzle hole should line up with the Injector Throat.