Hague Quality Water 96MM, Руководство пользователя, Страница: 32 / 40

Series 96 DRAIN END CAP ASSEMBLY
Series 96 Owner’s Manual
30
Figure 10
NO. PART NO. QTY ITEM DESCRIPTION
1 93808 1 End Cap O-ring
2 90268 1 Drain End Cap Seals the left opening on the Main Valve Body. The opening is sealed with an
O-ring used as an axial or "face" seal. The O-ring sits in a groove in the Drain
End Cap. This groove must be free of defects such as pits or scratches and
also free of debris. When assembling the Drain End Cap to the Valve Body,
care should be taken to make sure that the O-ring stays in the groove in the
Drain End Cap. If misaligned, the O-ring can become pinched and leak.
3 H2086-2.4* 1 Drain Line Flow Maintains a constant (plus or minus 10%) backwash flow rate at varying
H2086-3.0* Control Button pressures. Care should be taken when replacing Drain Line Flow Control
Buttons to ensure that the correct rate is being used for a particular model.
Flow Control Button should be assembled with lettering facing retainer.
4 90267 1 Retainer Holds the backwash Flow Control Button in place. One side is smooth and the
other has a groove for a screw driver. When assembling the retainer to the
Drain End Cap, the retainer should be "screwed" in until it stops. If the retainer
is not fully engaged, the Flow Control may not function properly.
V185 1 Drain Line Fitting (Not supplied)
(Not Shown)
90614-2.4 Drain End Cap Assembly (contains all of the above items.)
90614-3.0 (optional). 96MMB1 or p1 only.
*The numbers after the Drain Line Flow Control Button Part # indicate the backwash flow rate in gpm.