Hach LANGE ULTRATURB sc, Руководство по эксплуатации

Страница: 49 / 73

44
Operation
5.11.2 SENSOR-SETUP
WIPE Initiates a wiping action
VERIFY
Verification using CVM
module
Verification with dry standard
CALIBRATION
STANDARD
Selection as per
CAL.CONFIG OUTPUT
MODE
Calibration with standard
solution Procedure during calibration, menu
based
OFFSET
Selection as per
CAL.CONFIG OUTPUT
MODE
Zero point setting Zero point setting, menu based
CAL. FACTOR
FAC. STANDARD 0.50 to 2.00
OFFSET -0.100 to +0.100 TRBFNU
CAL. CONFIG
OUTPUT MODE
HOLD
ACTIVE
TRANSFER
SELECTION
Behaviour of the outputs during
calibration or zero point setting
CAL INTERVAL Adjustable from 0 to 365 days
SET CAL DEFLT Reset to the default calibration
CONFIGURATION
LOCATION
SET DEFAULTS Instrument
number
up to 16-character name possible
MEAS UNIT
mg/l, FNU, NTU, TE/F,
EBC SET DEFAULTS
FNU
CLEANING
SET DEFAULTS
12 h 10 min, 20 min, 30 min,
2 h, 6 h, 12 h, 10:00
RESPONSE TIME
SET DEFAULTS
15 s
0 to 60 s
LOGGERINTERV.
SET DEFAULTS
10 min
1-30 min
RESOLUTION
SET DEFAULTS
0,xxx
0,xxx or 0,xxxx (<1 FNU)
SET DEFAULTS Confirmation prompt
Reset to default configuration for all
menu commands listed above.
MAIN MENU
DIAG DIAG
SELECT SENSOR
TEST/MAINT
客服：400 688 9809