H3C WX5004, Руководство по установке

Страница: 27 / 85

3-7
Installing the Access Controller with Mounting Brackets and Slide Rails
z
Slide rails are optional components, which need to be separately ordered if needed.
z
H3C slide rails are suitable for only the H3C standard racks with a depth of 1000 mm (39.37 in.). If
the depth of your rack is different, substitute other supports for the slide rails.
Slide rail appearance
Figure 3-12
Appearance of a slide rail
(1) Slotted hole, a screw hole for fixing the slide rail to the rear round-hole rack rail of the rack. You
can adjust the screw position within the screw hole according to the device position.
(2) Heat dissipation hole. It is for heat dissipation between the device and rack.
(3) Slotted hole, a screw hole for fixing the slide rail to the front round-hole rack rail of the rack.
Installation procedure
1) Put on the EAD-preventive wrist strap and check that the rack is sturdy and properly earthed.
2) Take out the screws, which are packaged with the front mounting brackets. Attach one end of the
front mounting brackets to the access controller with the screws, as shown in Figure 3-4 .
3) Install the slide rails to the round-hole rack rails at both sides of the rack using M5 tapping screws,
as shown in Figure 3-13 . (This figure is just for your reference. The installation may differ on a
different rack.)
Figure 3-13
Install slide rails