40
Installing the system board
Follow the reverse order of removal to install the system board.
Replacing a drive backplane
Guidelines
WARNING!
To avoid bodily injury from hot surfaces, allow the server and its internal modules to cool before
touching them.
Prerequisites
Take the following ESD prevention measures:
•
Wear antistatic clothing.
•
Wear an ESD wrist strap and make sure it makes good skin contact and is reliably grounded.
•
Do not wear any conductive objects, such as jewelry or watches.
Before installing, make sure that you back up the data, stop all services, and power off the server.
For more information, see "
Remove the blade server. For more information, see "
When you replace a component, examine the slot and connector for damages. Make sure the pins
are not damaged (bent for example) and do not contain any foreign objects.
You might also remove other components. For the removed components to be reinstalled correctly,
record their positions and connections before removal, for example, taking pictures of cable
connection and drive installation positions, or labeling cables.
Removing a drive backplane
1.
Remove the drives attached to the backplane.
2.
Remove the access panel. Press the unlock button on the access panel, slide the panel to the
serve rear, and lift the access panel.
3.
Remove the drive backplane. Release the ejector levers, hold the drive backplane by the
ejector levers, and pull the backplane out of the chassis.
Installing a drive backplane
1.
Install a drive backplane. Insert the drive backplane into the chassis along the guide rails, and
then close the ejector levers.
2.
Install the access panel. Align the standouts on the access panel with the notches in the chassis
side panels, place the panel onto the chassis, and slide the access panel to the server front until
it is secured into place.
3.
Install the removed drives.
4.
Install the blade server. For more information, see "
5.
Power on the blade server. For more information, see "
