H3C UniServer B5800 G3, Руководство пользователя

Страница: 28 / 78

20
Installing a mezzanine network adapter
1. Remove other mezzanine network adapters that might hinder your installation, if any.
2. Install the mezzanine network adapter. Insert the adapter onto the mezzanine module
connector on the system board, and use screws to secure the adapter.
3. Install other mezzanine modules removed before, if any.
4. Install the access panel. Align the standouts on the access panel with the notches in the chassis
side panels, place the access panel onto the chassis, and slide the panel to the server front until
the panel is securely locked.
5. Install the blade server. For more information, see " Installing the blade server ."
6. Power on the blade server. For more information, see " Powering on the blade server ."
Replacing a SATA M.2 SSD
To configure RAID settings after the SSD is replaced, see the storage controller user guide for the
server.
Guidelines
WARNING!
To avoid bodily injury from hot surfaces, allow the server and its internal modules to cool before
touching them.
Replacing procedures are similar for the two SATA M.2 SSDs on the system board and this section
replace one SATA M.2 SSD as an example.
Install SATA M.2 SSDs that do not contain any RAID information.
For efficient use of storage, use SATA M.2 SSDs that have the same capacity to build a RAID. If the
SATA M.2 SSDs have different capacities, the lowest capacity is used across all SATA M.2 SSDs in
the RAID.
Prerequisites
Take the following ESD prevention measures:
•
Wear antistatic clothing.
•
Wear an ESD wrist strap and make sure it makes good skin contact and is reliably grounded.
•
Do not wear any conductive objects, such as jewelry or watches.
Identify the position of the SATA M.2 SSD to be replaced.
Identify the RAID array information of the SSD to be replaced. To replace an SSD that is not
configured with a RAID or is in a non-redundancy RAID array, back up all data.
Before replacing, make sure that you stop all services and power off the server. For more information,
see "
Powering off the blade server ."
Remove the blade server. For more information, see " Removing the blade server ."
When you replace a component, examine the slot and connector for damages. Make sure the pins
are not damaged (bent for example) and do not contain any foreign objects.
You might also remove other components. For the removed components to be reinstalled correctly,
record their positions and connections before removal, for example, taking pictures of cable
connection and drive installation positions, or labeling cables.