42
3.
(Optional) Remove the blank from the drive slot, if any. Pressing the red button on the blank to
the right, pull the blank out of the slot.
4.
Install the drive. Press the button on the drive panel to release the locking lever, and then insert
the drive into the drive slot.
5.
After the storage controller detects the new SAS/SATA drive, please confirm whether to
configure RAID according to the actual situation. For the method of configuring RAID, refer to
the storage controller user guide of the product.
Verifying the replacement
Use one of the following methods to verify that the drive has been replaced correctly:
•
Verify the drive properties (including capacity) by using one of the following methods:
Log in to OM. For more information, see the OM online help.
Log in to HDM. For more information, see
H3C Servers HDM online help
.
Access the BIOS. For more information, see the storage controller user guide for the server.
Access the CLI or GUI of the server.
•
Observe the drive LEDs to verify that the drive is operating correctly. For more information
about drive LEDs, see "
Replacing an NVMe drive
To configure RAID settings after the drive is replaced, see the storage controller user guide for the
server.
Operation scenario
•
The drive fails.
•
Expand the drive.
•
Replace the drive with full space.
•
Replace the drive with another model.
•
The drive hinders maintenance of other parts.
Prerequisites
Take the following ESD prevention measures:
•
Wear antistatic clothing.
•
Wear an ESD wrist strap and make sure it makes good skin contact and is reliably grounded.
