52
b.
(Optional) Remove the PCIe card filler panel. Lift the filler panel up and remove it from the
riser card.
c.
InstallIng PCIe card to riser card connector Insert the PCIe NIC along the PCIe connector
on the riser card, and then close the PCIe card fixing buckle.
2.
Install the riser card with the PCIe NIC in the blade server.
a.
(Optional) Remove the filler panel. Lift the filler panel up.
b.
Install the riser card with the PCIe NIC in the blade server. Insert the riser card downward as
aligning the two mushroom-shaped heads on the riser card with the two notches on the
blade server.
3.
Install the chassis cover. Place the chassis cover horizontally downward as aligning the
mushroom-shaped head on the chassis cover with the groove on the chassis, and slide the
chassis cover toward the front of the server until it is locked.
4.
Install the blade server.
5.
Power on the blade server. For more information, see "
Removing a mezzanine network adapter
1.
Remove the access panel. Press the unlock button on the access panel, slide the access panel
to the server rear, and lift the panel.
2.
Remove other mezzanine network adapters that might hinder your operation, if any.
3.
Remove the mezzanine network adapter. Loosen the captive screws that secure the adapter,
and then lift the adapter out of the chassis.
Installing a mezzanine network adapter
1.
Remove other mezzanine network adapters that might hinder your installation, if any.
2.
Install the mezzanine network adapter. Insert the adapter onto the mezzanine module
connector on the system board, and use screws to secure the adapter.
3.
Install other mezzanine modules removed before, if any.
4.
Install the access panel. Align the standouts on the access panel with the notches in the
chassis side panels, place the access panel onto the chassis, and slide the panel to the server
front until the panel is securely locked.
5.
Installing the blade server
6.
Power on the blade server. For the specific steps, see "
."
Replacing a SATA M.2 SSD
This section describes the detailed steps for replacing the SATA M.2 SSD module.
