H3C SR6608/6604 Routers Installation Manual
Chapter 1 Router Overview
1-26
Item
Specification
Function
Used for router software upgrading and
network management
Note:
The media dependent interface (MDI) standard is typically used on the Ethernet
interface of network adapters. The media dependent interface crossover (MDI-X)
standard is typically used on hubs or LAN switches.
X. RESET button
To reset the current RPE-X1, you can press the RESET button.
If you press the RESET button when only one RPE-X1 is equipped, the whole
system will be reset.
If you want to perform an active-standby switchover when two RPE-X1s are
equipped, press the RESET button on the active RPE-X1. The system will
automatically switch the services to the standby RPE-X1, without interrupting the
ongoing services.
If you press the RESET button on the standby RPE-X1 when two RPE-X1s are
equipped, the standby RPE-X1 will be reset but the system operation will not be
affected.
The RUN LED goes off when the RPE-X1 is reset, flashes fast (at 8 Hz) when
BootWare is running, and flashes slowly (at 1 Hz) after the system is booted and
operates normally.
Note:
If you perform no save operation before resetting the router, the current system
configuration will not be saved after the router is reset.
Never press the RESET button when the RUN LED is blinking fast or when the
router is accessing the CF card or a USB storage device. Otherwise, the file system
of the router may be damaged.
XI. Clock
The device is designed with an internal clock module that provides the system time.
You can set the system time through a command line interface.
