H3C S5120-SI Series, Руководство по эксплуатации

Страница: 406 / 697

1-25
Follow these steps to specify the source IP address for RADIUS packets to be sent:
To do… Use the command… Remarks
Enter system view system-view —
radius nas-ip ip-address
Specify the source IP address
for RADIUS packets to be sent
radius scheme
radius-scheme-name
nas-ip ip-address
Required
Use either approach
By default, there is no source IP
address specified for RADIUS
packets and the IP address of
the interface for sending the
RADIUS packets will be used
as the source IP address of the
RADIUS packets.
The setting by the nas-ip command in RADIUS scheme view is only for the RADIUS scheme, while that
by the radius nas-ip command in system view is for all RADIUS schemes. However, the setting in
RADIUS scheme view takes precedence over that in system view.
Setting Timers Regarding RADIUS Servers
When communicating with the RADIUS server, a device can enable the following three timers:
z
RADIUS server response timeout ( response-timeout ): If a NAS receives no response from the
RADIUS server in a period of time after sending a RADIUS request (authentication/authorization or
accounting request), it has to resend the request so that the user has more opportunity to obtain
the RADIUS service. The NAS uses the RADIUS server response timeout timer to control the
transmission interval.
z
Primary server quiet timer ( timer quiet ): If the primary server is not reachable, its state changes to
blocked, and the device will turn to the specified secondary server. If the secondary server is
reachable, the device starts this timer and communicates with the secondary server. After this
timer expires, the device turns the state of the primary server to active and tries to communicate
with the primary server while keeping the state of the secondary server unchanged. If the primary
server has come back into operation, the device interacts with the primary server and terminates its
communication with the secondary server.
z
Real-time accounting interval ( realtime-accounting ): This timer defines the interval for performing
real-time accounting of users. After this timer is set, the switch will send accounting information of
online users to the RADIUS server at the specified interval.
Follow these steps to set timers regarding RADIUS servers:
To do… Use the command… Remarks
Enter system view system-view —
Enter RADIUS scheme view
radius scheme
radius-scheme-name
—
Set the RADIUS server
response timeout timer timer response-timeout
seconds
Optional
3 seconds by default