Installation
G&D FIBREVision ·
11
Connections for data transmission and power supply
Remove the protection cap from both the
Transmission
interface and the cable plugs.
Transmission – Tx:
Insert the LC plug of the fibre optic cable (available as accessories)
into this interface. Connect the other end of the cable to the
Transmission – Rx
inter-
face of the computer module.
Transmission – Rx:
Insert the LC plug of the fibre optic cable (available as accessories)
into this interface. Connect the other end of the cable to the
Transmission – Tx
inter-
face of the computer module.
Power:
Insert the supplied
PowerCable-2 Standard
IEC cable.
Red. Power:
Connect the
Power-Set 12/Type 2
power pack to establish a second, redun-
dant power supply for the computer module.
Figure 6: Interfaces
for data transmission and power supply
IMPORTANT:
The device uses components with laser technology which corre-
spond to the laser class 1. Although class 1 laser beams are considered as being
nonhazardous, the direct eye contact with the laser has to be avoided. Do not look
into the beam with optical instruments.