GULLCO Pipe Kat PK-500-LG Series, Руководство по эксплуатации

Страница: 11 / 54

7
MOUNTING PIPE BAND (TRACK) ON THE PIPE
1. Loosen latch screws on both top swing latches and bottom fixed latches. Do not remove
these screws.
2. Swing open the top pair of latches.
3. Separate or split the two bottom halves (fixed latches) of track away from each other.
Important ! The bottom halves must be a minimum of 3/16” [5mm] apart from each
other. This minimum distance will allow the track to safely open without causing
interference between the two track halves.
4. Place track on pipe by sliding over the end, or by opening the track to fit over the pipe
outside diameter.
5. Close latch over catch and tighten adjustment screw enough to allow the track to move,
but still remain on the pipe.
6. Align track to weld joint. The optimal distance is approximately 8.00” [203.2 mm]
between the inside edge of track and the center of the weld joint. NEVER use a hammer
or other such object to hit the Pipe Band into position, doing so will damage the edge
that the self-aligning wheels run on and result in poor performance.
7. Back off the adjustable standoffs on the pipe band. This is done by rotating the
adjustment screw counter clock-wise.
8. Finish tightening the top and bottom latch screws. The track must be sufficiently
fastened to remove any gaps between the ends of track at the joint. Do not over-tighten!
9. Verify track position on the pipe and then begin to tight each adjustable track standoff. It
is important that each standoff be adjusted by the same amount. By not doing this the
track will not be concentric with the pipe. See below for more details.
Track standoff assembly
Adjustment screw:
-Counter clock-wise to loosen
-Clock-wise to tighten
Adjustable range of
track mounting pad.
+/-0.157” [4mm]