GULLCO Pipe Kat PK-500-LG Series, Руководство по эксплуатации, Страница: 17 / 54

13
to control and maintain the quality of the welding process. Width is increased or decreased in
0.01 Inch/CM increments.
OSCILLATION CENTER POSITION ADJUSTMENT: This adjustment knob allows the operator
to adjust the center position of the torch oscillation while in the auto cycle mode (welding) or to
jog the torch to the desired position prior to welding. This serves as a fine adjustment to control
and maintain the quality of the welding process. To make adjustments (steering) while welding,
rotate the knob in the appropriate direction until the center of the oscillation has moved to the
desired location. The size of these centre adjustment (steering) increments can be programmed
to be as large or small as preferred (see the “2
nd
Field” details on page 23).
TORCH SLIDE JOG: This 3-position momentary switch (In/Stop/Out) allows the operator to
adjust the In/Out distance of the torch relative to the work. The torch slide provides 2” or
[50.8mm] of motorized travel and can be used in both auto and manual modes. This serves as a
fine adjustment to control and maintain the tip-to-work distance. The linear speed of the slide
can be programmed through the Carriage Control (see page 36).
WELD ENABLED/DISABLED: This 2-position maintained switch allows the user to perform
simulated auto cycles, without actually welding, when in the Disable ( ) position (i.e. when an
auto cycle is initiated the wire feeder, the welding power source, and the shielding gas flow are
disabled). When in the Enabled (
) position the auto cycle will perform a weld cycle (see page
41).
PIPE KAT
®
CARRIAGE
WIRE FEED
PINCH ROLLER
PRESSURE
ADJUSTMENT
LOCKING
HANDLES
WIRE SPOOL
TENSION
ADJUSTMENT
EMERGENCY
STOP
CARRIAGE
ELECTRODE
CABLE
CONNENCTION
CARRIAGE
CONTROL
CONNECTION
CARRIAGE DRIVE
MOTOR