GULLCO Pipe Kat PK-500-LG Series, Руководство по эксплуатации

Страница: 16 / 54

12
RED POWER LED: The red LED is illuminated to indicate there is power to the pendant. It also
flashes whenever there is an error code displayed on the controls.
WIRE FEED SPEED TRIM OVERRIDE: This speed adjustment knob allows for fine adjustment
in wire feed when the PIPE KAT
®
is in auto cycle mode (welding), this serves as a fine
adjustment to control and maintain the quality of the welding process. Adjustment range: +/- 19
inches/minute or +/- 48 cm/minute.
CARRIAGE WELD SPEED OVERRIDE: This speed adjustment knob allows for fine adjustment
in carriage weld speed when the PIPE KAT
®
is in auto cycle mode (welding), this serves as a
fine adjustment to control and maintain the quality of the welding process. Adjustment range: +/-
1.32 inches/minute or +/- 3.36 cm/minute.
WELDING VOLTAGE CONTROL: This adjustment knob allows for adjustment of the welding
voltage during setup or in auto mode. Note: welding voltage control is only available when the
PIPE KAT
®
is interfaced with the welding power source; see “Welding power source calibration”
on page 37 for more details.
WIRE FEED JOG: This 3-position momentary switch (Forward/Auto/Reverse) allows for
manual forward and reverse feeding of the welding wire when not in the auto cycle mode. The
switch is automatically disabled during the auto cycle.
CARRIAGE JOG: This 3-position momentary switch (Forward/Auto/Reverse) allows for manual
forward and reverse motion of the carriage when not in the auto cycle mode. Use the carriage
jog switch to establish the proper position of the carriage to the work prior to welding. When the
forward or reverse jog direction is selected, the carriage will travel at the set carriage (weld)
travel speed for three (3) seconds then it will progressively ramp up to maximum travel speed.
The switch is automatically disabled during the auto cycle.
EMERGENCY STOP: The emergency stop button serves as a safety feature that will terminate
all operations and shut down the PIPE KAT
®
unit when pressed. The emergency stop will
remain activated until it is reset by turning the button in a clock-wise motion. There are two (2)
other such emergency stop buttons; one (1) on the PIPE KAT
®
carriage assembly and one (1)
on the Main Control Box. These three (3) Emergency Stop buttons are wired in series, so any
one (1) will shut down the PIPE KAT
®
system when activated, and all three have to be released
in order for the system to power-up.
GREEN LED: The green LED is illuminated when the PIPE KAT
®
is operating in the auto cycle
mode.
AUTO CYCLE START PUSH BUTTON: This green button is used to initiate the auto cycle
mode. The button must be held for a minimum of two (2) seconds to reduce the possibility of
accidentally starting an automatic operation.
AUTO CYCLE STOP PUSH BUTTON: This red button is used to terminate the auto cycle
mode. The button must be held for a minimum of two (2) seconds to reduce the possibility of
accidentally aborting the automatic operation.
OSCILLATION WIDTH ADJUSTMENT: This adjustment knob allows the operator to adjust the
torch oscillation width while in the auto cycle mode (welding). This serves as a fine adjustment