GULLCO Pipe Kat PK-500-LG Series, Руководство по эксплуатации

Страница: 35 / 54

31
operator to navigate through the different fields (indicated by the selected field flashing) by
rotating the knob either clockwise or counter-clockwise.
PROGRAMMING BUTTON:
The Program push button changes the control state from running (operational) mode to
programming mode, and back to running mode. While-ever the control is in programming mode,
the program icon on the lower right corner of the LCD screen will appear as follows.
WIRE FEED SPEED (Mean Setting):
This rotary switch increases (clockwise adjustment) or decreases (counter-clockwise
adjustment) the mean setting of the Wire Feed Speed. This is referred to as the ‘mean setting’
because there is a trim override adjustment on the remote pendant which allows the operator to
fine tune the Actual Wire Feed Speed to their liking by increasing or decreasing the wire speed
by six (6) increments of 3.2 inches/minute [8 cm/minute]. The main screen displays both the
mean setting of the Wire Feed Speed and the Actual Wire Feed Speed (mean s/- the
trim override setting) in the units of choice (either inches or centimeters per minute). Speed
adjustments can be changed at any time before or during operation and will take effect
immediately.
While in programming mode this switch allows the operator to increase or decrease values in
the selected (flashing) field by rotating the knob clockwise or counter-clockwise.
SHIELDING GAS PURGE:
This momentary button is used to purge the shielding gas line prior to welding to ensure
shielding gas will be present at the torch when welding commences.
AUTO CYCLE STOP:
This momentary push button (or the Auto Cycle Stop push button located on the remote
pendant) is used to terminate the automatic welding process. When in programming mode this
push button is used to navigate from screen to screen (page to page).
CARRIAGE WELD DIRECTION:
This momentary push button allows the operator to program the travel direction of the
carriage during an automatic welding cycle. The direction of travel is indicated on the display by
an arrow superimposed on the image that symbolizes the welding carriage. Whenever this
button is pushed the arrow on the display will change (flip) to acknowledge the change in will
welding direction. See page 33 for the display screens that depict all combinations of carriage
direction and torch dwell position.
Note: Changes in welding direction can only be made while the carriage is at rest and not in
automatic cycle or while being manually jogged.
Carriage with locking handles shown
Carriage welding direction arrow