37
2.
Wet a soft cloth completely with distilled water or deionized water,
to wipe all the surfaces of the components such as handpiece, charger,
base, etc. until the surface of the component is free of debris or stains.
3.
Wipe the surface of each component with a dry soft nap-free cloth.
4.
Repeat the above steps at least 3 times.
Note:
a) Use distilled water or deionized water for cleaning at room
temperature.
6.3.1.2
Manual disinfection steps:
1.
Soak the dry soft cloth with 75% alcohol.
2.
Wipe all surfaces of headpiece, charger, base and other components
with a wet soft cloth for at least 3 minutes.
3.
Wipe the surface of the component with a dry soft nap-free cloth.
Note:
a)
The cleaning and disinfection must be performed within 10min
before use.
b)
The disinfectant used must be used immediately, no foaming is
allowed.
c)
In addition to 75% alcohol, non-residue disinfectants such as
Oxytech from Germany can be used, but the concentration, temperature
and time specified by the disinfectant manufacture must be followed.
d)
After cleaning and disinfecting the handpiece, disposable isolation
sleeve should be installed before use and repeat steps 1, 2 and 3 to clean
the disposable isolation sleeve (For detailed installation steps, see section
2.7).
6.3.2
Post-Op processing
After each use, clean and disinfect the handpiece, charger, and base
within 30 minutes. The specific steps are as follows:
Tools: Nap-free soft cloth, tray
1.
Remove the contra-angle from the handpiece, place it in a clean tray,
and then remove the disposable isolation sleeve from the handpiece.
2.
Wet nap-free soft cloth with distilled water or deionized water, should be
used to wipe all the surfaces of the components such as handpiece, charger,
base, etc. until the surface is free of debris or stains.
3.
Wet the dry soft cloth with 75% alcohol, and then wipe all surfaces
of the handpiece, charger, base and other components for 3 minutes.
4.
Place the handpiece, charger, base and other components back into
a clean storage area.
Содержание Ai-Motor MotoPex
