Radio Box: Mount the on/off switch into radio box A
with the "on" side facing toward the inside of the buggy.
You may install the silicone switch cover included in your
kit over the switch before installation. Install radio box A
and radio box B together using two 2x33mm BH screws.
Place the receiver and battery (flat or hump pack can be
used) inside the radio box. Route the antenna wire
through the small groove in the rear of the radio box.
Route the wire through the antenna tube and
secure the antenna tube in the mount in the
radio box. Before securing the lid with the
body pins, route the servo leads into the
radio box. Refer to your radio instruction
manual for proper wiring. Secure lid with
4mm body pin.
Servos: Attach radio post C to the radio tray,
hex side down. Attach throttle servo (shown at
top of drawing) to radio tray using servo mount.
Attach radio post B to radio tray and throttle servo.
Note direction of radio post B. Attach the steering
servo (shown at the bottom of the diagram) to radic
tray posts A and B. Note direction of radio post A.
Do not over tighten any of the screws, only tighten
until snug. Route the steering servo wire
around the outside of the
throttle servo, away
from the center
of the car.
