Exploded V i e w w i t h Key Numbers
Front Lower Arms: The front lower left
arms on the STORM CL-1 are not identical and can not be
used on either side. Thread a 4x12mm set screw through the
hole on the tab of the inside of the arm. Tighten it until it sticks out
2.5mm below the arm. This is the rear down stop adjustment.
Front Sway Bar: Place the front sway
bar in the grooves of the Bulkhead-A.
Place the sway bar plate over the sway bar, lining up the holes in the plate with
the holes in the Bulkhead-A. Fasten the sway bar plate to the Bulkhead-A by using two
3x8 FH/ST screws. The 3x4 set screws shown in the diagram are used to hold the sway
bar in place, but should not be tightened to the point of causing the sway bar to bind. Some
racers choose not to use these set screws. Check to make sure the sway bar rotates freely. Fasten
the sway bar mounts using the 3x3mm set screws onto the sway bar.
Tighten screws
equally
