Exploded V i e w w i t h Key Numbers
Brake Pads: Place both Center Diff Mount-A pieces flat on a table, smooth
side down. Locate and inspect the brake pad/caliper assemblies. The
brake pads and calipers included in your kit may come pre-glued. You
will notice that one of the holes in each assembly is elongated. Make 2
pairs of brake pad/caliper assemblies (as shown in diagram) so that the
elongated holes line up. Place the assemblies over the mounts, lining up
the holes in the mounts and the brake assemblies. Thread two 3x14 cap
screws through the brake assemblies and tighten until there is
approximately a 2.0mm gap between the outer brake caliper and the
bottom of the cap portion of the screw. Later, you may readjust this
setting if the brakes are too tight or too loose.
