Exploded V i e w w i t h Key Numbers
Front/Rear Conical Gear: Slide the bearing over the output shaft of the front/rear conical gear. Apply
a light coat of grease to the male portion of the front/rear diff out drive and insert it through the spur gear.
Apply a very light coat of grease to the o-ring, then slide it over the shaft of the out drive and seat it in the
spur gear. Slide the shim on the shaft and over the o-ring. Insert the pin through the hole in the shaft of
the out drive. Check to make sure the out drive rotates freely. If it does not, make sure the o-ring is
properly seated and/or apply a bit more grease to the o-ring. Slide the large bevel gear over the pin.
Repeat for second conical gear.
ASSEMBLED VIEW
