Throttle/Brake Linkage: Thread the ball cup onto a throttle rod
until tight. Slide a 2mm stopper over the throttle rod followed by the
linkage spring, throttle rod support, and 2mm stopper. Tighten the
last stopper only to keep the parts in place for now. Install this
throttle linkage assembly to the 3rd hole in the servo horn using
the 3x12 cap screw and 3mm lock nut. You may have to enlarge the
hole slightly. Do not over tighten, make sure the linkage rotates freely.
Slide the adjuster knobs onto the middle of the remaining 2 throttle
(brake) rods and tighten in place. Thread one rod into the upper
brake rod support and one into the lower brake rod support. Mount
the upper and lower brake rod supports onto the 2nd hold of the
servo horn (opposite the throttle) using a 2x15 RH screw. Make
sure the linkage rotates freely.
Rear Shocks: Attach the rear shocks
to the shock tower first, using the 3mm washer and locknuts.
Attach the shocks to the lower arms at the outside holes of the arms using 3x20 OH screws.
Basic Set Up
REAR SUSPENSION
