Water Softener
Weichwassermeister
®
GSX 5, GSX 10, GSX 10-I
Order no.-Nr. 075 187 970-inter Edited by: KONS-nkes-mrie G:\BA-187970-INTER_GSX 5-10.DOC
8
4.4 Protection from water damage
Warning!
In order to properly protect the installation site from water damage:
a)
a sufficient floor drain system must be available or
b)
a water stop device (refer to chapter C – Optional accessories) must
be installed.
4.5 Indication of
specific hazards
Danger due to electricity!
Do not touch electrical parts with wet
hands! Disconnect the system from mains before starting work on elec-
trical parts of the system. Have qualified experts replace damaged cables
immediately.
Danger due to mechanical energy! System parts may be subject to
overpressure. Danger of injury due to escaping water and unexpected
movement of system parts.
Check pressure pipes regularly. Depres-
surise the system before starting repair or maintenance work on the
system.
Hazardous to health due to contaminated drinking water!
The sys-
tem may only be installed by a qualified company. The operation manu-
al must be strictly adhered to! Ensure that there is sufficient flow. The
pertinent guidelines must be followed for starting-up after long periods
of standstill. Inspections and maintenance must be performed at the
intervals specified!
Note:
By concluding a maintenance contract, you ensure that all of the
required tasks are performed on time. You may perform the interim
inspections yourself.
5 | Shipping and storage
Attention!
The system may be damaged by frost or high temperatures.
In order to avoid damage of this kind:
Protect from frost during shipping and storage! Do not install or store
system next to objects which radiate a lot of heat.
6 | Disposal of used parts and materials
Used parts and materials are to be disposed of, or made available for
recycling purposes, according to the applicable local guidelines.
If a material is subject to specific regulations, adhere to the notes indi-
cated on the packing.
If in doubt, contact your local waste disposal authority or the manufac-
turer for more information.
