Water Softener
Weichwassermeister
®
GSX 5, GSX 10, GSX 10-I
Order no. 075 187 970-inter Edited by: KONS-nkes-mrie G:\BA-187970-INTER_GSX 5-10.DOC
35
2.2 How to set the op-
erating parameters
Basic setting (User Programming level)
In its basic setting, the display indicates the time (colon is blinking). First,
access the User Programming level.
1.
Keep key pressed for more than 2 seconds.
The display indicates the hours.
2.
Press key. The displayed hours start blinking.
3.
Set current time (hours). In order to do so:
Decrease the hours by means of key.
Increase hours by means of key.
4.
Save setting by pressing key. The displayed hours stop blinking.
5.
Press key to access the next menu item.
The display indicates the minutes.
6.
Press key. The displayed minutes start blinking.
7.
Set current time (minutes). In order to do so:
Decrease the minutes by means of key.
Increase the minutes by means of key.
8.
Save setting by pressing key. The displayed minutes stop
blinking.
9.
Press key to switch to the next menu item.
2
°dH
The display indicates the stored raw water hardness.
10.
Here, the actual raw water hardness at the operating site must be
entered. The raw water hardness can be determined by means of
the water test kit “total hardness” or requested from the local wa-
ter supplier (factory-setting: 25 °dH, 25 °f, 2,5 mmol/l).
11.
Enter the appropriate value. To do so, repeat steps 6. - 8. accordingly.
Note:
In case of fluctuating raw water hardness, the highest value that
might occur has to be entered!
