G0513 Series Bandsaws (Mfd. Since 08/22)
-53-
Ripping
"Ripping" means cutting with the grain of the
wood stock. For plywood and other processed
wood, ripping simply means cutting down the
length of the workpiece. Beveled rip cuts may be
performed by tilting the table.
To make a rip cut:
1. Adjust fence to match width of cut on your
workpiece, then lock fence in place.
2. Adjust blade guide assembly to proper height
above workpiece.
3. After all safety precautions have been met,
turn bandsaw
ON and wait for it to come to
full speed. Slowly feed workpiece into blade
until blade is completely through workpiece.
Figure 79 shows an example of a ripping
operation.
Figure 79. Example of a ripping operation.
NEVER place fingers or hands in the line of
cut. If you slip, your hands or fingers may
go into the blade and may be cut.
ALWAYS use a push stick when ripping
narrow pieces. Failure to follow these
warnings may result in amputation or
laceration injuries!
Crosscutting
Crosscutting is the process of cutting across the
grain of wood. For plywood and other processed
wood, crosscutting simply means cutting across
the width of the material. Crosscuts can be 90° or
angled using the miter gauge. Compound cross-
cuts are those where the miter is angled and the
table tilted.
To make a crosscut:
1. Mark workpiece on edge where you want to
begin cut.
2. Adjust blade guide assembly to proper height
above workpiece.
3. Adjust miter gauge to correct angle needed
for cut.
4. Move fence out of the way. Place workpiece
evenly against miter gauge, then line up mark
with blade.
5. After all safety precautions have been met,
turn bandsaw
ON and wait for it to come to
full speed. Slowly feed workpiece into blade
until blade is all the way through workpiece.
Figure 80 shows an example of a crosscut-
ting operation.
Figure 80. Example of a crosscutting operation
with the miter gauge.
Содержание EXTREME G0513X2
Страница 100: ......
