Grizzly EXTREME G0513X2, Руководство пользователя

Страница: 40 / 100

-38-
G0513 Series Bandsaws (Mfd. Since 08/22)
Aligning Table
To ensure cutting accuracy, the table should be
aligned so that the miter slot is parallel to the
bandsaw blade, and that the table is perpendicu-
lar (front to back) to the blade. These procedures
work best with a wide (
3
⁄
4
") blade installed.
Tools Needed Qty
Straightedge ...................................................... 1
Fine Ruler .......................................................... 1
Square ............................................................... 1
Wrench or Socket 13mm ................................... 1
1. Make sure that the blade is tracking prop-
erly and that it is correctly tensioned (refer to
Pages 34–35).
2. DISCONNECT MACHINE FROM POWER!
3. Place an accurate straightedge along blade
so that it lightly touches both front and back
of blade without going across a tooth (see
Figure 55).
4. Use a fine ruler to measure the distance
between the straightedge and the miter slot
(see
Figure 55). The distance should be the
same at the front and the back of the table.
— If the distance is the same at the front
and back of the table, no adjustment is
necessary; proceed to
Adjusting Table
Perpendicular to Blade on Page 39.
— If the distance is not the same at the front
and back of the table, it must be adjusted;
proceed to
Step 5.
Adjusting Miter Slot Parallelism
Figure 55. Checking miter slot parallelism.
Straightedge
Fine Ruler
5. Loosen trunnion bolts that secure table (see
Figure 56).
Figure 56. Location of trunnion bolts.
Trunnion Bolts
(3 of 4)
6. Adjust table until distance between straight-
edge and miter slot is the same at front and
back of table.
7. Retighten trunnion bolts, then repeat Step 4
to verify adjustment.