9
STEP 3
ELECTRICAL CONNECTION AND DOOR ATTACHMENT
STEP 4
CONNECT BATTERIES
DISCONNECTING BATTERIES
Connect the operator to the mains power supply using the pre-connected mains plug to a 10A general power outlet
NOTE: After electrical connection, J-bar can be attached to door bracket by activating the operator. Press the "MOVE
GATE" buttons to position the trolley / J-bar assembly so it can be attached to the door bracket. Push arm should be
approx 20° from vertical
The batteries are charged in the circuit by the integrated transformer. The batteries are for battery backup
1.
SEE WARNING!
Unplug the J15 plug labelled BATT on the control board by squeezing the plug and pulling it from the control
board. This disconnects the ac/dc power to the control board
2. Loosen the screws on the battery cover and rotate out of the way
3. Connect the red wire to the positive (+) terminal on one battery and connect the black wire to the negative (-) terminal
on the other battery
4. Connect the black jumper (included with the batteries) between the positive (+) terminal of one battery to the
negative (-) terminal of the other battery
5. Insert the batteries as shown
6. Reattach the battery cover
7. Insert the J15 plug back into the control board. This will power up the control board. NOTE: You may see a
small spark when plugging the J15 plug into the board
8. Turn ON AC power at the wall switch
9. Turn ON the AC power switch on the rear of the operator
1. Turn OFF the AC power switch on the rear of
the operator
2. Turn OFF the power at the wall switch
3.
SEE WARNING
Remove the J15 plug from the
control board
4. Loosen the screws on the battery cover and
rotate out of the way
5. Carefully remove batteries and disconnect all
wires from the battery terminals
6. Dispose of used batteries responsibly
7. Follow instructions above to connect new
batteries
OPERATOR WILL NOT FUNCTION WITHOUT
GRIFCO BATTERIES CONNECTED
INSTALLATION
Black jumper
provided with
batteries
Black Wire (-)
Red Wire (+)
J15 Plug
1/7
9
2/6
3
4
5
WARNING
Batteries are supplied charged. When batteries are connected the operator is fully functional without AC power connected.
NOTE: Batteries are supplied fully charged.
They are automatically charged when
operator is connected to mains power.
WARNING
FAILURE TO DISCONNECT J15 PLUG LABELLED BATT WILL RESULT
IN POTENTIAL SHOCK HAZARD (FOLLOW STEP 4, POINT 1)
