15
COMMISSIONING REMOTE TRANSMITTERS (SOLD SEPARATELY)
ERASING TRANSMITTERS OR LIMITS
MOUNTING GSD-STAR1000EVO
A total of 50 S 2.0 remote transmitters and 2 wireless
keypads (1 PIN for each wireless keypad) can be programmed to
the operator. When programming a third wireless keypad to the
operator, the first wireless keypad will be erased to allow the third
wireless keypad to be programmed.
When the operator’s memory is full it will exit the programming
mode and the remote transmitter will not be programmed. The
memory will need to be erased before programming any additional
remote transmitters.
Ensure supplied antenna is fitted to the operator prior to
programming transmitters.
The operator will automatically exit learn mode (operator will beep and green XMITTER LED will go out) if programming is successful. To
program additional S 2.0 remote transmitters or transmitter buttons, repeat the programming steps above.
OPTION
DESCRIPTION
PROGRAM USING OPERATOR'S LEARN BUTTON
Single button as OPEN
only
Program a single button on the
remote transmitter for open only.
The Timer-to-Close can be set to
close the door.
1.
Press and release the LEARN button (operator will beep and green XMITTER LED
will light). NOTE: The operator will time out of programming mode after 30 seconds.
2.
Press the OPEN button.
3.
Press the remote transmitter button that you would like to program.
Single button (SBC) as
OPEN, CLOSE, and STOP
(Remote transmitter
behaviour will become
"open only" when TTC is
set
Program one transmitter button
as an open, close, and stop.
1.
Press and release the LEARN button (operator will beep and green XMITTER LED
will light). NOTE: The operator will time out of programming mode after 30 seconds.
2.
Press the remote transmitter button that you would like to program.
Three separate buttons as
OPEN, CLOSE, and STOP
Program each remote transmitter
button as an open, close, and
stop.
1.
Press and release the LEARN button (operator will beep and green XMITTER LED
will light). NOTE: The operator will time out of programming mode after 30 seconds.
2.
Press the OPEN, CLOSE, or STOP button, depending on the desired function.
3.
Press the remote transmitter button that you would like to program.
COMMISSIONING
ERASE ALL CODES
1. Press and release the LEARN button (operator will beep and green XMITTER LED will light).
2. Press and hold the LEARN button again until the green XMITTER LED flashes and then release the button (approximately 6 seconds). All
remote transmitter codes are now erased
The GSD-STAR1000EVO (sold separately) is designed to fit internally to the operator.
1. Mount the STAR1000EVO device to the mounting bracket
2. Mount the assembly (STAR1000EVO and bracket) to the internal chassis of the
operator using the at the position shown right using the screws and bracket provided
(ensure the antenna is mounted external to the operator)
3. Connect the cable to the Main Control Board as shown on page 18.
ERASE LIMITS
1. To erase the limits, press and hold the SET OPEN and SET CLOSE buttons simultaneously (5 seconds) until both the SET OPEN and
SET CLOSE LEDs blink rapidly and the operator beeps.
2. Release the buttons and the SET OPEN and SET CLOSE LEDs will blink slowly indicating the limits have been erased.
Mounting position of
GSD-STAR1000EVO
