GRAUPNER Micro Star 1000, Руководство пользователя

Страница: 23 / 36

Micro Star 1000
23
2. Set-up procedure
2.1 Setting up the cyclic control system
The basic settings for the roll-axis and pitch-axis control systems should already be correct if
you have set up the linkages as described earlier in these instructions. Since the lever lengths
are pre-defined, the final set-up should be carried out using the electronic facilities provided by
your transmitter.
2.2 Main rotor pitch settings
The main rotor pitch is best measured using a blade pitch gauge (not included in the kit). The
following table shows the recommended basic settings, but the optimum values may well vary
slightly according to your particular model and the rotor blades you are using.
Minimum Hover Maximum
Hovering and practice -3 ... 0° 3 ... 5° 7 ... 10°
Aerobatics -10 ... -7° 0° 7 ... 10°
Auto-rotation -3° 6° 11°
The best way of setting the correct blade pitch values on the transmitter is as follows:
1. Measure the hovering pitch and set it to the correct value.
2. Measure collective pitch maximum and minimum and adjust the values according to the fol-
lowing diagrams, using your transmitter's collective pitch curve facility
2.3 Setting up the motor control system
The main rotor speed should be around 1600 rpm for hovering. For aerobatics the ideal speed is
between 2100 and 2200 rpm.
The following diagrams show two alternative motor control curves: