GRAUPNER Micro Star 1000, Руководство пользователя

Страница: 16 / 36

Micro Star 1000
16
Set the three pushrods to the stated lengths, and use them to connect the swashplate to the
bellcranks.
Fit the prepared tail rotor head on the tail rotor shaft, as shown in Fig. 16. Please note the follow-
ing points:
The M3 x 3 grubscrew must engage in the depression in the tail rotor shaft; tighten it fully in this
position. The blade holder linkage point is at the leading edge of each rotor blade; bear this in
mind when assembling the blades and the control bridge.
Fig. 16: Assembling the tail rotor head
Checking the installation:
If you rotate the main rotor clockwise as seen from above, the tail rotor should turn anti-
clockwise when viewed from the right-hand side; the lower tail rotor blade should move forward
(toward the nose), the upper blade should move aft. This tail rotor arrangement is known as
“lower blade advancing”.