GRAUPNER Micro Star 1000, Руководство пользователя

Страница: 19 / 36

Micro Star 1000
19
The carbon fibre stabiliser panels should be fixed to the tail boom using the fittings included in
bag “F”, as shown in Fig. 21. The horizontal stabiliser is installed using the two-part clamp; ini-
tially fit just the two M2 x 16 screws and the two M2 nuts on the underside; don’t fit the two M2 x
14 screws at this point, as they are used later to retain the tail boom braces.
Fig. 21: Installing the stabiliser panels
You will find the tail rotor pushrod in bag “G”. Slip the pushrod through the pushrod guide on the
horizontal stabiliser clamp, as shown in Fig. 22. Screw ball-links on both ends, then connect
them to the tail rotor servo and the tail rotor bellcrank. Adjust the length of the pushrod so that
the tail rotor blades are either at neutral, or exhibit a very small pitch angle to the right, when the
servo is at centre (servo output arm at right-angles to the pushrod).
Fig. 22: Tail rotor pushrod