GRAUPNER GmbH & Co. KG D-73230 KIRCHHEIM/TECK GERMANY
Modifications reserved. No liability for printing errors.
12/2011
Made in
Vietnam
9
Now mark the position of the axle holes in the wheel yoke on the wheel spat, and drill
the holes to match the diameter of the wheel axle. Install the wheel and the collets as
shown in the photo. The wheel axle should project by an equal amount on both sides
of the wheel spat.
The nosewheel unit can now be slid into the bearing hole in the noseleg bracket from
the underside, fitting the steering arm on it at the same time
To avoid having to dismantle the noseleg unit again, the steering pushrod should be
connected to the outer hole in the steering arm at this stage. Run the pushrod
through the guide tube, and glue the sleeve to the formers and other wooden parts.
Installing the tailplane and fin
Insert the hinges and horns in the appropriate slots in the tailplane and elevators, as
described for the ailerons, and glue them in place.
