GRAUPNER GmbH & Co. KG D-73230 KIRCHHEIM/TECK GERMANY
Modifications reserved. No liability for printing errors.
12/2011
Made in
Vietnam
5
Set the servos to centre from the transmitter. The wing-mounted servos are attached
to the support blocks using the retaining screws supplied with them: the first step is to
push the rubber grommets into the servo mounting lugs, followed by the brass tubular
spacers, with the flange on the underside. The spacers are easier to fit if you slip
them on a suitable screwdriver first. Drill 1.5 mm Ø pilot-holes in the support blocks,
using the metal spacers as a guide, then fit the servo retaining screws as shown.
The servo leads can now be pulled through the wing panels using a length of thread:
tie the thread to the servo lead just behind the connector, then pull it through until it
appears at the root rib.
Fit the servo mounts in the wings and secure them with the retaining screws sup-
plied.
Mark a centreline on all the aileron hinges using a pencil, as shown in the photo.
