GRAUPNER GmbH & Co. KG D-73230 KIRCHHEIM/TECK GERMANY
Modifications reserved. No liability for printing errors.
12/2011
Made in
Vietnam
6
The hinges can now be inserted in the ailerons as far as the pencil lines, and glued in
place using cyano; a syringe needle works well as a nozzle.
When the glue has set hard, insert the projecting hinges into the slots in the wings
and glue them in place with cyano. Note that there should be a gap about 0.5 mm
wide at the hinge line.
Shorten the GRP horns to the point where only the bottom linkage hole remains.
Use the tip of a hot soldering iron to remove the covering film over the horn slots, and
glue the horns in them using UHU plus (epoxy).
Ensure that the clevis linkage holes are exactly in line with the hinge pivot axis.
The aileron pushrods can be assembled when the glue has set hard. Adjust the
pushrod length so that the aileron is central when the servo is at neutral.
