GRAUPNER GmbH & Co. KG D-73230 KIRCHHEIM/TECK GERMANY
Modifications reserved. No liability for printing errors.
12/2011
Made in
Vietnam
3
Creases:
Blow warm air over the area and rub down with a soft cloth.
Wing warp: Hold the panel twisted gently in the opposite direction to the warp, and
apply warm air to remove the creases from the covering.
Caution! do not heat the film more than is absolutely necessary. If the air or the
iron is too hot, the film may melt and holes may be formed.
This aeroplane is highly pre-fabricated and can be built in a very short time.
However, the work which you have to carry out is important and must be done
carefully. The model will only be strong and fly well if you complete your tasks
competently - so please work slowly and accurately.
When self-tapping screws have to be screwed into wood, apply a little white
glue to prevent them shaking loose: just squirt white glue into the hole before
fitting the screw.
Additional items required
Glowplug engine
Engine
Order No.
Propeller
Order No.
OS MAX 65 AX
2771
33 x 18 cm
1318.33.18
Electric motor and accessories
Electric motor
Order No.
Propeller
Order No.
Flight battery
Order No.
Speed controller
Order No.
COMPACT
465 Z
7772
1318.36.20
9733.4
7224
Radio control system
The RC system must feature at least four channels and five servos. The trans-
mitter should also include a servo reverse facility.
We particularly recommend MX-12 to mc-24 computer systems. Standard-sized ser-
vos are required for rudder, elevator and throttle.
For the ailerons the model needs servos with a case width of 13 mm.
We recommend the following receiver power supply: LiPo 2/1600, Order No. 9717.2,
in conjunction with the PRX 3A ON / OFF switch, Order No. 4135; these batteries
need to be maintained carefully before and after each flying session.
For more information please refer to the instructions supplied with your RC system,
rechargeable batteries, etc.
