GRAPHTEC CUTTING PRO FC3100-60, Руководство по обслуживанию

Страница: 20 / 175

FC3100-60 Service Manual
P/N53802-031T Rev. A
2 - 10
•
Pen UP Movement Control (PEN UP MOVE)
When the plotter receives commands that specify consecutive pen movements in raised status, this
function determines whether to move the pen to each coordinate point or to move the pen directly to the
final coordinate point.
When ENABLED is selected, the pen moves to each coordinate point in sequence.
When DISABLED is selected, the pen moves directly to the final coordinate point.
•
ON/OFF Control of the Paper Size Sensor in the Film Feeding Direction (MAINTENANCE 1)
This function lets you disable the sensor which detects paper size in the film feeding direction.
When ON is selected, the sensor is disabled.
When OFF is selected, the sensor is enabled.
•
ON/0FF Control of Paper Width Sensor (MAINTENANCE 2)
This function lets you disable the sensor which detects the width of the paper.
When ON is selected, the paper width sensor is disabled.
When OFF is selected, the paper width sensor is enabled.
•
Setting the MAINTENANCE 3 Function
When this function has been set to ON and the medium has been loaded a second time after the plotter
has been turned on, the plotter will assume that the medium has been reloaded and will then display the
menu for setting the CONTINUE mode.
If it has been set to OFF, the plotter does not display the CONTINUE menu.
If the CONTINUE mode is enabled when loading the medium, the medium's size will not be detected.
During long-axis plotting or other cases where the medium is likely to come loose of the pinch rollers,
the medium can be reloaded by pressing the [ PAUSE ] key to temporarily suspend the operation in
progress.
Notes on Setting the CONTINUE Mode
* When the MAINTENANCE 3 function has been set to ON, the pen carriage will not be release even if
the film set lever is lowered.
* The CONTINUE menu does not appear when the plotter is turned on or during initial paper selection
after the plotter has been reset.
* Even if the film set lever is lowered during plotting, the plotting operation will not be stopped. To
discontinue plotting, make sure to press the [ PAUSE ] key before lowering the film set lever.
* If the right pinch roller is moved when loading the medium, the pen carriage may strike the Stopper.
To change the position of the pinch roller after having selected CONTINUE mode at the paper selection
menu, turn off the plotter first.