GRAPHTEC CUTTING PRO FC3100-60, Руководство по обслуживанию

Страница: 125 / 175

FC3100-60 Service Manual
P/N53802-031T Rev. A
6 - 2
(5) After the RAM check, the menu below appears.
No matter which mode you select, detection of the paper width will be disabled.
(6) Set the plot area.
Caution : Unless the plot area is set, the cutting mat may be damaged.
Method 3: MAINTENANCE 2 (Paper Width Sensor)
(1) While holding down the [
⇓
] POSITION key, turn on the plotter. (Continue holding down the [
⇓
]
key while the RAM is being checked.)
(2) Consecutively press the [ NEXT ] key until the menu below appears.
(3) Press the [ 2 ] (ON) key so that the flashing cursor moves to the ON position, then press the [ ENTER
] key.
(4) Turn the plotter off then back on again.
(5) After the RAM check, the menu below appears.
(6) The paper detection status varies with the mode you select as follows.
ROLL-1 Detects the paper's front edge
ROLL-2 Disables paper size detection; the initial pen position is the origin (0,0)
SHEET Detects the paper’s front and rear edges
(7) Set the plot area.
Caution : Unless the plot area is set, the cutting mat may be damaged and a position error may be
caused by the pen block striking the side plate.