GRAPHTEC CUTTING PRO FC3100-60, Руководство по обслуживанию

Страница: 129 / 175

FC3100-60 Service Manual
P/N53802-031T Rev. A
7 - 3
Problem Cause Solution
See User's
Manual,
Section:
•
Characters or lines are
deformed during pen
plotting.
•
The plotter is in Cutting
mode.
•
Set the blade type of the
CUTTER OFFSET function to
PEN (0).
4.5
•
Film is fed at an angle.
•
Film has been loaded at an
angle.
•
Correctly reload the film.
4.2
•
The roll guides are not in
the correct location.
•
Line up the roll guides with
the edges of the roll of film
and secure in place with the
screws.
4.2
•
The total amount of roll film
to be cut was not pulled out
in advance.
•
Pull out the required amount
of film in advance. 4.2
•
Film is abruptly fed
forward.
•
Incorrectly selected film
type.
•
Correctly set the film type to
match your film.
4.2
•
The length of cutting
results differ from the
program. (slight
distance error)
•
The film is slipping.
•
Lower the cutting SPEED or
the PEN UP SPEED setting.
4.5
5.10
•
The distance correction
requires adjustment.
•
Adjust the distance
correction.
5.16
•
Film is loaded but the
LOAD PAPER !!
prompt appears.
•
Film that is nearly
transparent cannot be
detected by the paper sensors.
•
Disable the paper sensors by
turning off the Maintenance 1
function, then set the effective
cutting area at the control
panel.
5.19
•
Strong reflected light is
preventing the paper sensors
from detecting the film.
•
Change the position of the
light source. 1.3
•
The loaded film has not
been positioned over the
paper sensors.
•
Properly reload the film.
4.2
•
Cut characters are
deformed.
•
The Step Pass is too high.
•
Lower the Step Pass setting.
5.13
•
The starting and end
points of cutting do not
match.
•
Coordinate points are
incorrectly specified.
•
The Offset Cut Pressure is
too low.
•
The film is too flimsy.
•
Blade rotation is not
smooth.
•
Check the coordinate data by
plotting it with a pen.
•
Raise the Offset Cut Pressure.
•
Switch to a stronger film.
•
Grease the cutter blade and
holder
4.6
5.11
3.4