GRAPHTEC CUTTING PRO FC3100-60, Руководство по обслуживанию

Страница: 59 / 175

FC3100-60 Service Manual
P/N53802-031T Rev. A
4 - 23
(6) To attach the pen block, reverse the procedure while paying attention to the following points.
* Attach a ceramic pen and ensure a clearance of 3 mm (nominal error: +0.3 mm, -0 mm) between
the cutting mat's upper surface and the ten tip.
* Visually check that the pen block's bottom surface is parallel to the cutting mat's surface.
Fig. 4-53
* When securing the pen block, avoid scratching the slide shaft with the screwdriver or other tool.
Fig. 4-54
* As shown in Fig.4-55, pass the pen block FPC cable below the MC block's reinforcing rib to
prevent damaged cable leads.
Fig. 4-55
* When securing the 60A FPC cable guide, be sure not to damage the pen block FPC cable.
(7) Adjust the pen servo system (see Section 5.9).