GRAPHTEC CUTTING PRO FC3100-60, Руководство по обслуживанию

Страница: 124 / 175

FC3100-60 Service Manual
P/N53802-031T Rev. A
6 - 1
6. TEMPORARY MEASURES FOR A SENSOR MALFUNCTION
If a symptom appears that indicates that a sensor has malfunctioned (for example, the paper size is not
detected or the medium falls off), the pertinent sensor can be disabled as a temporary measure.
Mode Information detected Compatible media
ROLL-1 Width and front edge Roll
ROLL-2 Width Roll
SHEET Width, front edge, back edge Single sheets
Method 1 : Set Bit 4 of the Main Board's DIP Switch to OFF
(1) Turn off the plotter.
(2) Remove the rear guide (see Subsection 4.1.2).
(3) Set Bit 4 of the main board's DIP switch to OFF.
(4) Attach the rear guide and turn the plotter back on.
(5) When the plotter is turned back on, the pen position becomes the origin (0,0) and the menu below
appears. (The paper selection menu disappears and the plot area menu appears instead.)
L represents the page length setting and S represents the maximum paper width.
(6) Set the plot area.
Caution : Unless the plot area is set, the cutting mat may be damaged and a position error may be
caused by the pen block striking the side plate.
Method 2: MAINTENANCE 1 (Front and Rear Paper Size Sensors)
(1) While holding down the [
⇓
] POSITION key, turn on the plotter. (Continue holding down the [
⇓
]
key while the RAM is being checked.)
(2) Consecutively press the [ NEXT ] key until the menu below appears.
(3) Press the [ 2 ] (ON) key so that the flashing cursor moves to the ON position, then press the [ ENTER
] key.
(4) Turn the plotter off then back on again. The initial pen position is the origin (0,0).