GRAPHTEC CE6000-120AP, Руководство пользователя

Страница: 199 / 227

12-11
Symptom LCD Display Possible Cause Solution
E01019 The plotter s defectve.
Load on the motor was too large.
Move the object dsturbng the operaton,
and turn on the plotter after turnng t off
once.
Do not use heavy meda.
E01021 The plotter s defectve.
Load on the motor was too large.
Move the object dsturbng the operaton,
and turn on the plotter after turnng t off
once.
Do not use heavy meda.
E01022 The plotter s defectve.
There was a heavy load on the up and
down functon of the tool carrage.
Please clear any obstructon n the up and
down functon of the tool carrage and turn
the power back on.
If the error dsplay contnues to show,
please contact the store where you bought
the product or our Customer Center.
E05001 Data larger than the buffer size cannot be
coped.
Perform normal cuttng not usng the copy
mode.
E05002 There s no data to copy. Perform normal cuttng by sendng the data,
then use the copy mode.
E05003 Meda vald area to copy s too small. Use larger meda.
Confirm the copy start position.
E05004 The push roller s not on the grt roller. Set the push roller on the grt roller.
E05005 Unable to perform cross cut. Unable to separate meda cuts. Check tool
blade and confirm media type.
E05006 Dstance between the bottom left and top
rght of the AREA settng s less than 10
mm.
Perform the AREA settng agan.
E05007 Test pattern for the TOOL OFFSET ADJ.
cannot start plottng because the start
poston s at the edge of the meda.
Set the start poston nsde the meda.