GRAPHTEC CE200-120, Руководство пользователя

Страница: 43 / 94

4 – 10
4.4.4 Specifying the CUTTER OFFSET
This setting adjusts the offset of the cutter blade according to the currently selected blade type. If the
blade type is set to PEN, a plotting pen can be used. When a cutter blade designation or OTHER is
selected, a cutter pen can be used. Because the tip of the blade mounted in the cutter pen plunger
is not positioned at the center of the pen, the cutting position is adjusted by specifying the CUTTER
OFFSET setting.
Since the cutting plotter has been preset with the optimum CUTTER OFFSET values for the CB09UA
and CB15U supersteel blade types, the optimum CUTTER OFFSET value can be easily selected by
simply selecting the corresponding blade number. Fine adjustment of these two settings is also possible
within a
±
5 range.
Step
1
After selecting the desired set of cutting conditions, check that the cutting plotter is in READY or PAUSE
status and then press the
F2/TEST
key to display the menu below.
TEST CUT
PEN SETTINGS
Step
2
Press the
F2/TEST
key (PEN SETTINGS) again to
display the menu below.
SPEED
PEN FORCE
Step
3
Press the
NEXT PAGE
key to display the menu below.
CUTTER OFFSET
QUALITY
Step
4
Press the
F1/ORIGIN
key (CUTTER OFFSET) to display the menu below.
CUTTER OFFSET
09U 0
At the above menu, use the or key to change the CUTTER OFFSET setting.
Use the or key to select the blade type (09U, 15U, OTHER, or PEN).
When a blade number (09U or 15U) is displayed, the and keys can be used to finely adjust
the setting within a
±
5 range.
When OTHER is displayed, the and keys can be used to specify the CUTTER OFFSET value
within a range of 1 to 45.
When PEN is displayed, no CUTTER OFFSET setting is required.
When the displayed CUTTER OFFSET value is satisfactory, press the
ENTER
key to register your setting.
Step
5
Consecutively press the
NEXT PAGE
key until the READY or PAUSE menu reappears.