GRAPHTEC CE200-120, Руководство пользователя

Страница: 31 / 94

3 – 11
3.4 Selecting the COMMAND Mode and INTERFACE Conditions
3.4.1 Selecting the COMMAND Mode
Before sending data from the computer, you must set up the cutting plotter so that it can recognize
the format (command mode) of data sent by the application software. The cutting plotter can recognize
two data formats (command modes): Graphtec commands (GP-GL) or HP-GL. Select the COMMAND
mode to suit your application.
Step
3
Press the
F1/ORIGIN
key (INTERFACE) to display the menu below.
RS-232C
COMMAND
Step
4
Press the F2/TEST key (COMMAND) to display the menu below.
GP-GL
HP-GL COMMAND
The blinking square cursor indicates the currently selected command mode.
Step
5
To select the GP-GL command mode, press the
F1/ORIGIN
key.
To select the HP-GL command mode, press the
F2/TEST
key.
When the cursor appears in front of the desired command mode, press the
ENTER
key.
Step
6
If you have changed the COMMAND setting, the menu for selecting the media mode appears.
ROLL 1
ROLL 2
Select the mode to suit the currently loaded medium as described in Section 3.3, “Loading the Medium.”
Step
7
If the COMMAND setting is GP-GL, proceed to select the STEP SIZE.
If the COMMAND setting is HP-GL, proceed to select the ORIGIN POINT.
Step
2
Press
PAUSE
key to enter PAUSE status.
Press the
NEXT PAGE
key until the menu below appears.
INTERFACE
PEN UP/DOWN
Step
1
After loading a medium, check that the menu below
is displayed.
COND1 PEN 12
== READY ==