GRAPHTEC CE200-120, Руководство пользователя

Страница: 30 / 94

3 – 10
Position the push roller (2) so that it is at the midpoint of the film and is also over the center grit roller.
The film is held in place using the three rollers called push rollers (1), (2), and (3).
Push roller (3)
Push roller
Grit roller
Film
Push roller(1)
Position the push roller (2) so that it is at the midpoint of the
film and is also over the center grit roller. Similar to the push rollers (1) and (3) in the figure below,
position the push roller (2) over a grit roller.
If the “RELOAD MEDIA!” message appears when you lower the media set lever, the right pinch roller
is not positioned over the wider grit roller on the right. This message also appears if the left pinch
roller is not positioned over a grit roller or is positioned over the wider grit roller on the right. Check
that the right pinch roller is positioned over the wider grit roller on the right and that the left pinch roller
is positioned over a grit roller other than the wider one on the right.
Step
4
If the cutting plotter has already been turned on when the push rollers are lowered by raising the media
set lever, a menu for selecting the media mode appears.
ROLL 1
ROLL 2
Press the
NEXT PAGE
key to proceed the display below.
SHEET
Press the
F1/ORIGIN
key to select the SHEET mode in which the leading and trailing edges of the media
are detected.
Step
5
After the medium size has been detected, the cutting plotter awaits cutting data.
If the INTERFACE conditions and COMMAND mode have not been selected yet, select these settings
at this time (see Section 3.4, “Selecting the COMMAND Mode and INTERFACE Conditions”). If they
have already been set, proceed to adjust the cutter pen. After the cutter pen has been adjusted (see
Chapter 4, “PREPARING FOR A CUTTING OPERATION”), the cutting plotter is ready to perform cutting
so send cutting data from your application software at the computer.